HP Serviceguard Version A.11.17 Release Notes, March 2006 (revised)

Serviceguard Version A.11.17 Release Notes
Known Problems and Workarounds
Chapter 1 51
Known Problems and Workarounds
The following lists known problems for Serviceguard Version A.11.16, at
time of publication. This list is subject to change without notice. Contact
your HP support representative for up-to-the-moment information. More
recent information on known problems and workarounds may be
available on the Hewlett-Packard IT Resource Center:
http://www.itrc.hp.com (Americas and Asia Pacific) or
http://www.europe.itrc.hp.com (Europe).
JAGaf75382 (SR8606415528): lan2 has an IPv6 address
(fec0:0:0:f08::36) but not in config. file
What is the problem? This happens ONLY with an IPv6
configuration.When a primary network interface configured with IPv6
address fails, AND when the switching of an IPv6 address encounters
ENOMEM, users will see a message like the following in syslog:
There is(are) 1 incidence(s) of :
Sep 11 16:34:38 ptest90 cmcld[11930]: Failed to switch
fec0:0:0:f08::36 from lan1:34(0) to lan2:27(3):
Not enough space
And then any subsequent SG config operations (like cmapplyconf etc.)
will fail with the following message:
Sep 11 17:33:29 (root@ptest90) cmapplyconf -f -v -C
/var/opt/sgtest/tmp/cmcluster/OPERATION_ptest90_2005
09091947.ascii
Checking cluster file:
/var/opt/sgtest/tmp/cmcluster/OPERATION_ptest90_200509091947
.ascii
Note : a NODE_TIMEOUT value of 2000000 was found in line 17.
For a significant portion of installations, a higher setting
is more appropriate. Refer to the comments in the cluster
configuration ascii file or Serviceguard manual for more
information on this parameter.