HP Serviceguard Version A.11.17 on HP-UX 11i v3 Release Notes, February 2007

Serviceguard Version A.11.17 on HP-UX 11i v3 Release Notes
Installing Serviceguard on HP-UX 11i v3
Chapter 140
Installing Serviceguard on HP-UX 11i v3
Dependencies
The following are required by Serviceguard. They are part of the HP-UX
Base Operating Environment:
• Open SSL, which includes the OPENSSSL-RUN and OPENSSL-LIB
filesets.
• The “EventMonitoring” bundle, which contains the EMS-CORE and
EMS-CORE-COM filesets.
Installing Serviceguard
Serviceguard will automatically be installed when you install the HP-UX
Mission Critical Operating Environment (MCOE).
To install Serviceguard independently, follow these broad steps:
NOTE This release of Serviceguard requires HP-UX 11i v3. If you are already
running earlier versions of Serviceguard and HP-UX, see “Upgrading
from an Earlier Serviceguard Release” on page 42 for more information.
Step 1. Install or upgrade to HP-UX 11i v3 before loading Serviceguard Version
A.11.17.01.
For information and instructions, see the HP-UX 11i v3 Installation and
Update Guide at http://docs.hp.com: choose 11i v3 under Operating
Environments and then choose Installing and Updating.
Step 2. Use the swinstall command to install Serviceguard, product number
T1905CA.
For more information about swinstall, see the swinstall(1M)
manpage and the Software Distributor Administration Guide for HP-UX
11i v3.
Step 3. Verify the installation. Use the following command to display a list of all
installed components: