HP Serviceguard A.11.20- Managing Serviceguard Twentieth Edition, August 2011

Responses to Package and Service Failures
In the default case, the failure of a failover package, a generic resource, or of a service within the
package, causes the package to shut down by running the control script with the ‘stop’ parameter,
and then restarting the package on an alternate node. A package will also fail if it is configured
to have a dependency on another package, and that package fails. If the package manager
receives a report of an EMS (Event Monitoring Service) event showing that a configured resource
dependency is not met, the package fails and tries to restart on the alternate node.
You can modify this default behavior by specifying that the node should halt (system reset) before
the transfer takes place. You do this by setting failfast parameters in the package configuration
file.
In cases where package shutdown might hang, leaving the node in an unknown state, failfast
options can provide a quick failover, after which the node will be cleaned up on reboot. Remember,
however, that a system reset causes all packages on the node to halt abruptly without a clean
shutdown.
The settings of the failfast parameters in the package configuration file determine the behavior of
the package and the node in the event of a package or resource failure:
• If service_fail_fast_enabled is set to yes in the package configuration file,
Serviceguard will halt the node with a system reset if there is a failure of that specific service.
• If node_fail_fast_enabled is set to yes in the package configuration file, and the
package fails, Serviceguard will halt (system reset) the node on which the package is running.
NOTE: In a very few cases, Serviceguard will attempt to reboot the system before a system reset
when this behavior is specified. If there is enough time to flush the buffers in the buffer cache, the
reboot succeeds, and a system reset does not take place. Either way, the system will be guaranteed
to come down within a predetermined number of seconds.
“Choosing Switching and Failover Behavior” (page 132) provides advice on choosing appropriate
failover behavior.
Responses to Package and Generic Resources Failures
In a package that is configured with a generic resource and is running, failure of a resource prompts
the Serviceguard Package Manager to take appropriate action based on the style of the package.
For failover packages, the package is halted on the node on which generic resource failure occurred
and started on an available alternative node. For multi-node packages, failure of a generic resources
causes the package to be halted only on the node on which the failure occurred.
• In case of simple resources, failure of a resource must trigger the monitoring script to set the
status of a resource to 'down' using the cmsetresource command.
• In case of extended resources, the value fetched by the monitoring script can be set using the
cmsetresource command.
The Serviceguard Package Manager evaluates this value against the
generic_resource_up_criteria set for a resource in the packages where it is configured.
If the value that is set (current_value) does not satisfy the generic_resource_up_criteria,
then the generic resource is marked as 'down' on that node.
90 Understanding Serviceguard Software Components