HP Serviceguard A.11.20- Managing Serviceguard Twentieth Edition, August 2011

Possible node failures can be caused by the following conditions:
• HPMC. This is a High Priority Machine Check, a system panic caused by a hardware error.
• TOC
• Panics
• Hangs
• Power failures
In the event of a TOC, a system dump is performed on the failed node and numerous messages
are also displayed on the console.
You can use the following commands to check the status of your network and subnets:
• netstat -in - to display LAN status and check to see if the package IP is stacked on the
LAN card.
• lanscan - to see if the LAN is on the primary interface or has switched to the standby interface.
• arp -a - to check the arp tables.
• lanadmin - to display, test, and reset the LAN cards.
Since your cluster is unique, there are no cookbook solutions to all possible problems. But if you
apply these checks and commands and work your way through the log files, you will be successful
in identifying and solving problems.
Troubleshooting the Quorum Server
NOTE: See the HP Serviceguard Quorum Server Version A.04.00 Release Notes for information
about configuring the Quorum Server. Do not proceed without reading the Release Notes for your
version.
Authorization File Problems
The following kind of message in a Serviceguard node’s syslog file or in the output of cmviewcl
-v may indicate an authorization problem:
Access denied to quorum server 192.6.7.4
The reason may be that you have not updated the authorization file. Verify that the node is included
in the file, and try using /usr/lbin/qs -update to re-read the Quorum Server authorization
file.
Timeout Problems
The following kinds of message in a Serviceguard node’s syslog file may indicate timeout
problems:
Unable to set client version at quorum server 192.6.7.2: reply timed
out
Probe of quorum server 192.6.7.2 timed out
These messages could be an indication of an intermittent network problem; or the default Quorum
Server timeout may not be sufficient. You can set the QS_TIMEOUT_EXTENSION to increase the
timeout, or you can increase the MEMBER_TIMEOUT value. See “Cluster Configuration Parameters
” (page 109) for more information about these parameters.
A message such as the following in a Serviceguard node’s syslog file indicates that the node
did not receive a reply to its lock request on time. This could be because of delay in communication
between the node and the Quorum Server or between the Quorum Server and other nodes in the
cluster:
338 Troubleshooting Your Cluster