HP Serviceguard A.11.20- Managing Serviceguard Twentieth Edition, August 2011

You can use Serviceguard Manager, or Serviceguard commands as shown below, to halt a
package.
Using Serviceguard Commands to Halt a Package
Use the cmhaltpkg command to halt a package, as follows:
cmhaltpkg pkg1
This halts pkg1, and, if pkg1 is a failover package, also disables it from switching to another
node.
You cannot halt a package unless all packages that depend on it are down. If you try, Serviceguard
will take no action, except to send a message indicating that not all dependent packages are
down. Before you halt a system multi-node package, or halt all instances of a multi-node package,
halt any packages that depend on them
Moving a Failover Package
You can use Serviceguard Manager, or Serviceguard commands as shown below, to move a
failover package from one node to another.
Using Serviceguard Commands to Move a Running Failover Package
Before you move a failover package to a new node, it is a good idea to run cmviewcl -v -l
package and look at dependencies. If the package has dependencies, be sure they can be met
on the new node.
To move the package, first halt it where it is running using the cmhaltpkg command. This action
not only halts the package, but also disables package switching.
After it halts, run the package on the new node using the cmrunpkg command, then re-enable
switching as described under “Using Serviceguard Commands to Start a Package” (page 285).
Changing Package Switching Behavior
There are two options to consider:
• Whether the package can switch (fail over) or not.
• Whether the package can switch to a particular node or not.
For failover packages, if package switching is set to NO the package cannot move to any other
node; if node switching is set to NO, the package cannot move to that particular node. For multi-node
packages, if package switching is set to NO, the package cannot start on a new node joining the
cluster; if node switching is set to NO, the package cannot start on that node.
Both node switching and package switching can be changed dynamically while the cluster is
running. The initial setting for package switching is determined by the auto_run parameter,
which is set in the package configuration file (page 235). If auto_run is set to yes, then package
switching is enabled when the package first starts. The initial setting for node switching is to allow
switching to all nodes that are configured to run the package.
You can use Serviceguard Manager to change package switching behavior, or Serviceguard
commands as shown below.
Changing Package Switching with Serviceguard Commands
You can change package switching behavior either temporarily or permanently using Serviceguard
commands. To temporarily disable switching to other nodes for a running package, use the
cmmodpkg command. For example, if pkg1 is currently running, and you want to prevent it from
starting up on another node, enter the following:
cmmodpkg -d pkg1
This does not halt the package, but will prevent it from starting up elsewhere.
286 Cluster and Package Maintenance