HP Serviceguard A.11.20- Managing Serviceguard Twentieth Edition, August 2011

The following states are possible only for multi-node packages:
• blocked — The package has never run on this node, either because a dependency has not
been met, or because auto_run is set to no.
• changing — The package is in a transient state, different from the status shown, on some
nodes. For example, a status of starting with a state of changing would mean that the
package was starting on at least one node, but in some other, transitory condition (for example,
failing) on at least one other node.
Package Switching Attributes
cmviewcl shows the following package switching information:
• AUTO_RUN: Can be enabled or disabled. For failover packages, enabled means that
the package starts when the cluster starts, and Serviceguard can switch the package to another
node in the event of failure.
For system multi-node packages, enabled means an instance of the package can start on a
new node joining the cluster (disabled means it will not).
• (Switching for a node.) Every failover package is marked enabled or disabled for each
node that is either a primary or adoptive node for the package.
For failover packages, enabled means that the package can switch to the specified node.
disabled means that the package cannot switch to the specified node until the node is
enabled to run the package via the cmmodpkg command.
For multi-node packages, node switching disabled means the package cannot start on that
node.
Service Status
Services have only status, as follows:
• Up. The service is being monitored.
• Down. The service is not running. It may not have started, or have halted or failed.
• Unknown.
Generic Resource Status
Generic resources have only status, as follows:
• Up. The generic resource is up.
• Down. The generic resource is down.
• Unknown. Resource monitoring has not yet set the status of the resource.
Network Status
The network interfaces have only status, as follows:
• Up.
• Down.
• Unknown. Serviceguard cannot determine whether the interface is up or down. A standby
interface has this status.
264 Cluster and Package Maintenance