HP Serviceguard A.11.20- Managing Serviceguard Twentieth Edition, August 2011

In addition to the above parameters, cvm_concurrent_dg_operations and
cfs_concurrent_mount_unmount_operations can also be modified online.
IMPORTANT: Modifying the cvm_disk_group, cfs_mount_point, ckpt_mount_point
or snapshot_mount_point is an offline operation. When you modify any of these parameters,
though cmapplyconf will succeed, it is considered that the existing disk group, mount point,
checkpoint mount point, or snapshot mount point are deleted and new ones are added respectively.
CAUTION: During online changes of modular CVM/CFS parameters, it is recommended not to
apply two CFS packages related to each other in the same cmapplyconf command. This is
because Serviceguard does not validate the inter-dependency existing between the packages
during cmapplyconf and as a result, it may cause the packages to fail.
NOTE: Some of the CVM/CFS parameters cannot be modified online and requires the package
to be halted. This is due to the limitation that changing CVM/CFS parameters while they are in
use is not supported by Symantec. So, it is recommended to do this only when applications that
depend on these packages are offline.
Example of online addition and deletion of a disk group and a mount point from a modular CFS
package
For online changes, the package must be up and running.
Consider a package cfspkg1 with the following configuration:
package_name cfspkg1
node_name node1
node_name node2
node_name node3
node_name node4
cvm_disk_group cvm_dg1_node1
cvm_activation_mode "node1=sw node2=sw node3=sw node4=sw"
cfs_mount_point /mnt1
cfs_volume cvm_dg1_node1/lvol1
cfs_mount_options "node1=cluster node2=cluster node3=cluster node4=cluster"
cfs_primary_policy ""
cvm_disk_group cvm_dg2_node1
cvm_activation_mode "node1=sw node2=sw node3=sw node4=sw"
cfs_mount_point /mnt2
cfs_volume cvm_dg2_node1/lvol1
cfs_mount_options "node1=cluster node2=cluster node3=cluster node4=cluster"
cfs_primary_policy ""
Before change:
cmviewcl -v -f line -p cfspkg1
cvm_concurrent_dg_operations=1
cvm_disk_group:cvm_dg1_node1|cvm_disk_group=cvm_dg1_node1
cvm_disk_group:cvm_dg1_node1|cvm_activation_mode=all=sw
cvm_disk_group:cvm_dg2_node1|cvm_disk_group=cvm_dg2_node1
cvm_disk_group:cvm_dg2_node1|cvm_activation_mode=all=sw
cfs_mount_point:/mnt1|cfs_volume=cvm_dg1_node1/lvol1
cfs_mount_point:/mnt2|cfs_volume=cvm_dg2_node1/lvol3
Now, delete the disk group cvm_dg1_node1, mount point /mnt2, and add a new disk group
cvm_dg0_node1 and mount point /mnt3.
After changing the parameters, check the configuration:
cmcheckconf -P cfspkg1.ascii
212 Building an HA Cluster Configuration