HP Serviceguard Quorum Server Version A.04.00 Release Notes, May 2014

4. Start the Quorum Server as follows:
• Edit the /etc/inittab file to add the Quorum Server entries, as shown in “Installing
the Quorum Server” (page 10).
• Use the init q command to run the Quorum Server.
Refer to the qs(1) man page for more details.
5. All nodes in all clusters that were using the old Quorum Server will connect to the new Quorum
Server. Use the cmviewcl -v command from any cluster that is using the Quorum Server to
verify that the nodes in that cluster have connected to the Quorum Server.
6. The Quorum Server log file on the new Quorum Server will show a log message such as the
following for each cluster that uses the Quorum Server:
Request for lock /sg/<ClusterName> succeeded. New lock owners: N1, N2
7. To check that the Quorum Server has been correctly configured and to verify the connectivity
of a node to the Quorum Server, you can execute the following command from your cluster
nodes as follows:
cmquerycl -q <QS_Host> -n <Node1> -n <Node2> ...
or (if you are using more than one subnet; see “Using Alternate Subnets” (page 13)):
cmquerycl -q <QS_Host> <QS_Addr> -n <Node1> -n <Node2> ...
The command will output an error message if the specified nodes cannot communicate with
the Quorum Server.
While the old Quorum Server is down and the new one is being set up, these things may happen:
• Commands: cmquerycl -q, cmapplyconf -C,and cmcheckconf -C not working.
• If there is a node or network failure that creates a 50-50 membership split, the Quorum Server
will not be available as a tie-breaker, and the cluster will fail.
CAUTION: Make sure that the old system does not re-join the network with its old IP address(es).
Uninstalling the Quorum Server
• To uninstall the Quorum server on Linux, use the rpm command:
rpm -e qs
• To uninstall the Quorum server on HP-UX, use the swremove command:
swremove B8467BA
Patches, Fixes, and Known Problems in this Version
This section describes patches that are required, defects that have been fixed in version A.04.00
of Quorum Server, and known problems.
Patches
Apart from the patches mentioned under “Compatibility with Serviceguard Versions” (page 9),
no other patches are needed for version A.04.00 and A.04.00.01 at the time of publication.
Contact your Hewlett-Packard support representative for up-to-the-moment information. Patches can
be created, superseded, or withdrawn at any time without notice. An updated list of patches is
available at Hewlett-Packard Support Centre website: http://www.hp.com/go/hpsc
Known Problems and Workarounds
There are no known problems with HP Serviceguard Quorum Server A.04.00 or A.04.00.01 at
the time of publication. Contact your Hewlett-Packard support representative for up-to-the-moment
information. Patches can be created, superseded, or withdrawn at any time without notice. An
20 HP Serviceguard Quorum Server Version A.04.00 Release Notes