HP Serviceguard Quorum Server Version A.04.00 Release Notes, May 2014
Table 2 Package Configuration File Parameters for qs-pkg (continued)
ValueParameter
NOSERVICE_FAIL_FAST_ENABLED
10SERVICE_HALT_TIMEOUT
If the Quorum Server connection is on a single subnet,
specify the subnet here.
SUBNET
5. Create a control script in the same directory:
cmmakepkg -s qs-pkg.ctl
6. Edit the file using the parameters in the following table.
Table 3 Package Control Script Parameters for qs-pkg
ValueParameter
IP address(es) to be used when accessing the Quorum Server. If you are using more
than one subnet for communicate between the Quorum Server and the cluster nodes,
make sure each address is on a different subnet.
IP[]
Specify your subnet(s) hereSUBNET[]
qsSERVICE_NAME[0]
(>> Redirect file in this example shows recommended log pathnames)SERVICE_CMD[0]
HP-UX: /usr/lbin/qs >> /var/adm/qs/qs.log 2>&1
Linux:
Red Hat: /usr/local/qs/bin/qs >> /var/log/qs/qs.log 2>&1
SUSE: /opt/qs/bin/qs >> /var/log/qs/qs.log 2>&1
“-R”SERVICE_RESTART
7. Update the authorization file if necessary.
See “Creating and Updating the Authorization File” (page 18).
8. Run the cluster and start the quorum server package.
Running the Quorum Server on a Single System
Specifying a Log File
By default, Quorum Server runtime messages go to stdout and stderr. HP recommends that
you create a directory such as /var/adm/qs, then redirect stdout and stderr to a file in this
directory (for example, /var/adm/qs/qs.log) when you start the Quorum Server; see the sample
/etc/inittab entries in the examples below. Recommended pathnames are in Table 3 (page 17).
Running the Quorum Server
NOTE: If you have just installed the quorum server, or if you are adding new cluster nodes, or
implementing the alternate-subnet functionality (for a cluster running a version of Serviceguard that
supports it.
see “Compatibility with Serviceguard Versions” (page 9)) you must update the authorization file
see “Creating and Updating the Authorization File” (page 18).
This section is not required if you are configuring quorum sever on Red Hat 6.0.
Configuring and Running the Quorum Server 17