HP Serviceguard Quorum Server Version A.02.00 Release Notes, Fifth Edition, February 2007

HP Serviceguard Quorum Server Version A.02.00 Release Notes, Fifth Edition
Installing the Quorum Server
Chapter 1 13
Installing the Quorum Server
Read this entire document and any other Release Notes or READMEs
you may have before you begin an installation.
The QS software, which has to be running during cluster configuration,
must be installed on a system other than the nodes on which your cluster
will be running. This could be a single Linux or HP-UX system, or it
could be a separate cluster.
If you are updating from an older version of Quorum Server, see
instructions below for updating.
Order is important if you are updating Quorum Server and also updating
Serviceguard to 11.14.02 or later. You must update Quorum Server first,
before updating Serviceguard. See migration instructions, below.
Installing on HP-UX
Use the swinstall command to install the QS, product number
B8467BA, on the system or systems where it will run. You must install
the Quorum Server on a node outside the cluster (or clusters) that it will
serve. The only installation required on the clusters that use the Quorum
Server lock is Serviceguard itself.
If you are updating from an earlier version of Quorum Server, skip to the
upgrading instructions below.
You can install in one of two ways:
• To install from the HP Serviceguard Distributed Components CD:
1. Mount the CD ROM, using /SD-CDROM as the mount directory.
2. Run the swinstall command.
3. When the window opens, set the Source Depot Type to Local
CDROM.
4. For the Source Depot Path, fill in the appropriate build:
/SD-CDROM/QuorumServer/HP-UX/11.11/quorumserver.depot
/SD-CDROM/QuorumServer/HP-UX/11.22/quorumserver.depot
/SD-CDROM/QuorumServer/HP-UX/11.23/eng.Notice.txt