Managing Serviceguard Extension for SAP Version A.06.00 for Linux, December 2012

Attributes offered by the liveCache module are:
DescriptionParameter (Example)Parameter
LC1lc_system
The virtual hostname onto which the
liveCache has been installed
reloc1lc_virtual_hostname
List of values which define into which
state the liveCache must be started.
onlinelc_start_mode
Possible values are offline, (only vserver
will be started) admin, (start in admin
mode) slow, (start in cold-slow mode)
online. (start in oline mode)
Key to access the liveCache as
described in previous step. Default is
‘c’.
clc_user_key
The Serviceguard Manager guided package setup offers discovered values, if a liveCache is
installed.
Check SAP liveCache instance in the initial SGeSAP module selection screen (Select a Toolkit ->
SGeSAP -> SAP liveCache instance).
The configuration dialogs brings up the screen for configuring the liveCache module.
Figure 22 Configuring sapextinstance screen
From the command line use:
cmmakepkg –m sgesap/livecache lcLC1.config to create the package configuration
file. Then edit and apply the configuration file.
NOTE:
• An SGeSAP liveCache package should not be configured with other SGeSAP modules, even
though it is technically possible .
• The SGeSAP easy deployment (deploysappkgs) script does not support liveCache.
Verification:
• Start up package on each configured node
• Make sure the liveCache can be accessed on each client node by executing dbmcli –U c
on these nodes
• Make sure SCM LC10 integration can connect every time
Completing SGeSAP package creation (Phase 3b) 77