Managing HP Serviceguard for Linux, Eighth Edition, March 2008

Cluster and Package Maintenance
Reviewing Cluster and Package Status
Chapter 7248
Script_Parameters:
ITEM STATUS MAX_RESTARTS RESTARTS NAME
Service up 0 0 service1
Subnet up 0 0 15.13.168.0
Node_Switching_Parameters:
NODE_TYPE STATUS SWITCHING NAME
Primary up enabled ftsys9 (current)
Alternate up enabled ftsys10
NODE STATUS STATE
ftsys10 up running
Network_Parameters:
INTERFACE STATUS NAME
PRIMARY up eth0
PRIMARY up eth1
PACKAGE STATUS STATE AUTO_RUN NODE
pkg2 up running enabled ftsys10
Policy_Parameters:
POLICY_NAME CONFIGURED_VALUE
Failover configured_node
Failback manual
Script_Parameters:
ITEM STATUS MAX_RESTARTS RESTARTS NAME
Service up 0 0 service2
Subnet up 0 0 15.13.168.0
Node_Switching_Parameters:
NODE_TYPE STATUS SWITCHING NAME
Primary up enabled ftsys10 (current)
Alternate up enabled ftsys9
NOTE The Script_Parameters section of the PACKAGE output of cmviewcl
shows the Subnet status only for the node that the package is running
on. In a cross-subnet configuration, in which the package may be able
to fail over to a node on another subnet, that other subnet is not shown
(see “Cross-Subnet Configurations” on page 30).
Quorum Server Status
If the cluster is using a quorum server for tie-breaking services, the
display shows the server name, state and status following the entry for
each node, as in the following excerpt from the output of cmviewcl -v: