Managing Serviceguard Extension for SAP, December 2007

SAP Master Data Management (MDM)
Installation and Configuration Considerations
Chapter 5 293
SERVICE_RESTART[0]=""
To activate the changes in the Serviceguard configuration files run the
following command:
cmapplyconf -P /etc/cmcluster/MDM/mdsMDM.config
Repeat the above steps for the mdbMDM, mdisMDM and mdsMDM packages.
NOTE The masterMDM Serviceguard package does not require a check function.
The only goal of this package is to coordinate a cluster wide start and
stop of the MDM server packages and therefore does not need a monitor.
MDM250 Setup Step:
Synchronize the /etc/cmcluster/MDM contents with second node
Synchronize the contents of directory /etc/cmcluster/MDM with the
second node using following command:
clunode1:
scp –pr /etc/cmcluster/MDM clunode2:/etc/cmcluster/MDM
MDM252 Setup Step:
(a) Single - Starting and Stopping the mgroupMDM package
Since everything is grouped in one package the following command will
start and stop the package and all it’s MDM server components (mdb,
mds, mdss and mdis) at the same time – on the cluster node the
cmrunpkg command is executed.
cmrunpkg mgroupMDM
cmrunpkg : Completed successfully on all packages
specified.
cmhaltpkg mgoupMDM