Using Serviceguard Extension for RAC Version A.11.20 - (August 2011)

• Creating RAC Volume Groups on Disk Arrays
• Creating Logical Volumes for RAC on Disk Arrays
The Event Monitoring Service HA Disk Monitor provides the capability to monitor the health of
LVM disks. If you intend to use this monitor for your mirrored disks, you should configure them in
physical volume groups. For more information, refer to the manual Using HA Monitors.
NOTE: When using LVM version 2.x, the volume groups are supported with Serviceguard. The
steps shown in the following section are for configuring the volume groups in Serviceguard clusters
LVM version 1.0.
For more information on using and configuring LVM version 2.x, see the HP-UX 11i Version 3:
HP-UX System Administrator's Guide: Logical Volume Management located at www.hp.com/go/
hpux-core-docs —> HP-UX 11i v3.
For LVM version 2.x compatibility requirements see the Serviceguard/SGeRAC/SMS/Serviceguard
Mgr Plug-in Compatibility and Feature Matrix at www.hp.com/go/hpux-serviceguard-docs
—> HP Serviceguard Extension for RAC.
NOTE: For more information, see the Serviceguard Version A.11.20 Release Notes at
www.hp.com/go/hpux-serviceguard-docs —> HP Serviceguard Extension for
RAC.
NOTE: The Oracle 11gR2 OUI allows only ASM over SLVM, ASM over raw device files, Cluster
File System for Clusterware files, and Database files.
Building Volume Groups for RAC on Mirrored Disks
The procedure described in this section uses physical volume groups for mirroring of individual
disks to ensure that each logical volume is mirrored to a disk on a different I/O bus. This kind of
arrangement is known as PVG-strict mirroring. It is assumed that your disk hardware is already
configured so that the disk can be used as a mirror copy, which is connected to each node on a
different bus other than the bus that is used for the other (primary) copy.
Creating Volume Groups and Logical Volumes
If your volume groups have not been set up, use the procedure in the next sections. If you have
already done LVM configuration, skip ahead to the section “Installing Oracle Real Application
Clusters” (page 47).
Selecting Disks for the Volume Group
Obtain a list of the disks on both nodes and identify which device files are used for the same disk
on both. Use the following command on each node to list available disks as they are known to
each system:
# lssf /dev/dsk/*
In the following examples, we use /dev/rdsk/c1t2d0 and /dev/rdsk/c0t2d0, which are
the device names for the same disks on both ftsys9 and ftsys10. In the event that the device
file names are different on the different nodes, make a careful note of the correspondences.
Creating Physical Volumes
On the configuration node (ftsys9), use the pvcreate command to define disks as physical
volumes. This only needs to be done on the configuration node. Use the following commands to
create two physical volumes for the sample configuration:
# pvcreate -f /dev/rdsk/c1t2d0
# pvcreate -f /dev/rdsk/c0t2d0
Creating a Storage Infrastructure with LVM 41