Using Serviceguard Extension for RAC, 8th Edition, March 2009

307200 sectors, 307200 blocks of size 1024, log size 1024 blocks
largefiles supported
12. Configure Mount Point
# cfsmntadm add cfsdg1 vol1 /cfs/mnt1 all=rw
The following output will be displayed:
Package name “SG-CFS-MP-1” was generated to control the resource.
Mount point “/cfs/mnt1” was associated with the cluster.
#cfsmntadm add cfsdg1 vol2 /cfs/mnt2 all=rw
The following output will be displayed:
Package name “SG-CFS-MP-2” was generated to control the resource.
Mount point “/cfs/mnt2” was associated with the cluster.
# cfsmntadm add cfsdg1 vol3 /cfs/mnt3 all=rw
The following output will be displayed:
Package name “SG-CFS-MP-3” was generated to control the resource.
Mount point “/cfs/mnt3” that was associated with the cluster.
NOTE: The diskgroup and mount point multi-node packages (SG-CFS-DG_ID# and
SG-CFS-MP_ID#) do not monitor the health of the disk group and mount point. They check
that the application packages that depend on them have access to the disk groups and mount
points. If the dependent application package loses access and cannot read and write to the
disk, it will fail; however that will not cause the DG or MP multi-node package to fail.
13. Mount Cluster Filesystem
# cfsmount /cfs/mnt1
# cfsmount /cfs/mnt2
# cfsmount /cfs/mnt3
14. Check CFS Mount Points
# bdf | grep cfs
/dev/vx/dsk/cfsdg1/vol1
10485760 36455 9796224 0% /cfs/mnt1
/dev/vx/dsk/cfsdg1/vol2
10485760 36455 9796224 0% /cfs/mnt2
/dev/vx/dsk/cfsdg1/vol3
307200 3246 284957 1% /cfs/mnt3
15. View the Configuration
# cmviewcl
CLUSTER STATUS
ever3_cluster up
NODE STATUS STATE
ever3a up running
ever3b up running
MULTI_NODE_PACKAGES
PACKAGE STATUS STATE AUTO_RUN SYSTEM
SG-CFS-pkg up running enabled yes
SG-CFS-DG-1 up running enabled no
SG-CFS-MP-1 up running enabled no
Creating a Storage Infrastructure with CFS 57