Using Serviceguard Extension for RAC, 7th Edition, September 2008

#
# QS_HOST qshost
# QS_POLLING_INTERVAL 120000000
# QS_TIMEOUT_EXTENSION 2000000
# Definition of nodes in the cluster.
# Repeat node definitions as necessary for additional nodes.
# NODE_NAME is the specified nodename in the cluster.
# It must match the hostname and both cannot contain full domain name.
# Each NETWORK_INTERFACE, if configured with IPv4 address,
# must have ONLY one IPv4 address entry with it which could
# be either HEARTBEAT_IP or STATIONARY_IP.
# Each NETWORK_INTERFACE, if configured with IPv6 address(es)
# can have multiple IPv6 address entries(up to a maximum of 2,
# only one IPv6 address entry belonging to site-local scope
# and only one belonging to global scope) which must be all
# STATIONARY_IP. They cannot be HEARTBEAT_IP.
NODE_NAME ever3a
NETWORK_INTERFACE lan0
STATIONARY_IP 15.244.64.140
NETWORK_INTERFACE lan1
HEARTBEAT_IP 192.77.1.1
NETWORK_INTERFACE lan2
# List of serial device file names
# For example:
# SERIAL_DEVICE_FILE /dev/tty0p0
# Primary Network Interfaces on Bridged Net 1: lan0.
# Warning: There are no standby network interfaces on bridged net 1.
# Primary Network Interfaces on Bridged Net 2: lan1.
# Possible standby Network Interfaces on Bridged Net 2: lan2.
# Cluster Timing Parameters (microseconds).
# The NODE_TIMEOUT parameter defaults to 2000000 (2 seconds).
# This default setting yields the fastest cluster reformations.
# However, the use of the default value increases the potential
# for spurious reformations due to momentary system hangs or
# network load spikes.
# For a significant portion of installations, a setting of
# 5000000 to 8000000 (5 to 8 seconds) is more appropriate.
# The maximum value recommended for NODE_TIMEOUT is 30000000
# (30 seconds).
HEARTBEAT_INTERVAL 1000000
NODE_TIMEOUT 2000000
# Configuration/Reconfiguration Timing Parameters (microseconds).
AUTO_START_TIMEOUT 600000000
NETWORK_POLLING_INTERVAL 2000000
# Network Monitor Configuration Parameters.
# The NETWORK_FAILURE_DETECTION parameter determines how LAN card failures are detected.
# If set to INONLY_OR_INOUT, a LAN card will be considered down when its inbound
# message count stops increasing or when both inbound and outbound
# message counts stop increasing.
# If set to INOUT, both the inbound and outbound message counts must
# stop increasing before the card is considered down.
NETWORK_FAILURE_DETECTION INOUT
# Package Configuration Parameters.
# Enter the maximum number of packages which will be configured in the cluster.
# You can not add packages beyond this limit.
# This parameter is required.
MAX_CONFIGURED_PACKAGES 150
# Access Control Policy Parameters.
#
# Three entries set the access control policy for the cluster:
# First line must be USER_NAME, second USER_HOST, and third USER_ROLE.
# Enter a value after each.
#
# 1. USER_NAME can either be ANY_USER, or a maximum of
86 Serviceguard Configuration for Oracle 9i RAC