Using Serviceguard Extension for RAC, 5th Edition, June 2007

Serviceguard Configuration for Oracle 10g RAC
Cluster Configuration ASCII File
Chapter 2 87
Cluster Configuration ASCII File
The following is an example of an ASCII configuration file generated
with the cmquerycl command using the -w full option on a system
with Serviceguard Extension for RAC. The OPS_VOLUME_GROUP
parameters appear at the end of the file.
# **********************************************************************
# ********* HIGH AVAILABILITY CLUSTER CONFIGURATION FILE ***************
# ***** For complete details about cluster parameters and how to *******
# ***** set them, consult the Serviceguard manual. *********************
# **********************************************************************
# Enter a name for this cluster. This name will be used to identify the
# cluster when viewing or manipulating it.
CLUSTER_NAME cluster 1
# Cluster Lock Parameters
# The cluster lock is used as a tie-breaker for situations
# in which a running cluster fails, and then two equal-sized
# sub-clusters are both trying to form a new cluster. The
# cluster lock may be configured using only one of the
# following alternatives on a cluster:
# the LVM lock disk
# the quorum server
#
#
# Consider the following when configuring a cluster.
# For a two-node cluster, you must use a cluster lock. For
# a cluster of three or four nodes, a cluster lock is strongly
# recommended. For a cluster of more than four nodes, a
# cluster lock is recommended. If you decide to configure
# a lock for a cluster of more than four nodes, it must be
# a quorum server.
# Lock Disk Parameters. Use the FIRST_CLUSTER_LOCK_VG and
# FIRST_CLUSTER_LOCK_PV parameters to define a lock disk.
# The FIRST_CLUSTER_LOCK_VG is the LVM volume group that
# holds the cluster lock. This volume group should not be
# used by any other cluster as a cluster lock device.
# Quorum Server Parameters. Use the QS_HOST, QS_POLLING_INTERVAL,