Using Serviceguard Extension for RAC, 3rd Edition, May 2006

Serviceguard Configuration for Oracle 10g RAC
Cluster Configuration ASCII File
Chapter 260
Cluster Configuration ASCII File
The following is an example of an ASCII configuration file generated
with the cmquerycl command using the -w full option on a system
with Serviceguard Extension for RAC. The OPS_VOLUME_GROUP
parameters appear at the end of the file.
# **********************************************************************
# ********* HIGH AVAILABILITY CLUSTER CONFIGURATION FILE ***************
# ***** For complete details about cluster parameters and how to *******
# ***** set them, consult the Serviceguard manual. *********************
# **********************************************************************
# Enter a name for this cluster. This name will be used to identify the
# cluster when viewing or manipulating it.
CLUSTER_NAME cluster 1
# Cluster Lock Parameters
# The cluster lock is used as a tie-breaker for situations
# in which a running cluster fails, and then two equal-sized
# sub-clusters are both trying to form a new cluster. The
# cluster lock may be configured using only one of the
# following alternatives on a cluster:
# the LVM lock disk
# the quorom server
#
#
# Consider the following when configuring a cluster.
# For a two-node cluster, you must use a cluster lock. For
# a cluster of three or four nodes, a cluster lock is strongly
# recommended. For a cluster of more than four nodes, a
# cluster lock is recommended. If you decide to configure
# a lock for a cluster of more than four nodes, it must be
# a quorum server.
# Lock Disk Parameters. Use the FIRST_CLUSTER_LOCK_VG and
# FIRST_CLUSTER_LOCK_PV parameters to define a lock disk.
# The FIRST_CLUSTER_LOCK_VG is the LVM volume group that
# holds the cluster lock. This volume group should not be
# used by any other cluster as a cluster lock device.
# Quorum Server Parameters. Use the QS_HOST, QS_POLLING_INTERVAL,