Using Serviceguard Extension for RAC, 2nd Edition, February 2005 Update
Table Of Contents
- Using Serviceguard Extension for RAC
- 1 Introduction to Serviceguard Extension for RAC
- 2 Serviceguard Configuration for Oracle RAC
- Planning Database Storage
- Installing Serviceguard Extension for RAC
- Configuration File Parameters
- Creating a Storage Infrastructure with LVM
- Building Volume Groups for RAC on Mirrored Disks
- Building Mirrored Logical Volumes for RAC with LVM Commands
- Creating RAC Volume Groups on Disk Arrays
- Creating Logical Volumes for RAC on Disk Arrays
- Oracle Demo Database Files
- Displaying the Logical Volume Infrastructure
- Exporting the Logical Volume Infrastructure
- Installing Oracle Real Application Clusters
- Cluster Configuration ASCII File
- Creating a Storage Infrastructure with CVM
- Initializing the VERITAS Volume Manager
- Preparing the Cluster for Use with CVM
- Starting the Cluster and Identifying the Master Node
- Converting Disks from LVM to CVM
- Initializing Disks for CVM
- Creating Disk Groups for RAC
- Creating Volumes
- Oracle Demo Database Files
- Adding Disk Groups to the Cluster Configuration
- Using Packages to Configure Startup and Shutdown of RAC Instances
- Starting Oracle Instances
- Creating Packages to Launch Oracle RAC Instances
- Configuring Packages that Access the Oracle RAC Database
- running cluster:adding or removing packages
- Writing the Package Control Script
- Using Serviceguard Manager to Write the Package Control Script
- Using Commands to Write the Package Control Script
- Customizing the Package Control Script
- Optimizing for Large Numbers of Storage Units
- Customizing the Control Script for RAC Instances
- Configuring an Oracle RAC Instance Package
- Using Serviceguard Manager to a Configure Oracle RAC Instance Package
- Enabling DB Provider Monitoring
- 3 Maintenance and Troubleshooting
- Reviewing Cluster and Package States with the
- Managing the Shared Storage
- Removing ServiceGuard Extension for RAC from a System
- Monitoring Hardware
- Adding Disk Hardware
- Replacing Disks
- Replacement of I/O Cards
- Replacement of LAN Cards
- Monitoring RAC Instances
- A Blank Planning Worksheets
Maintenance and Troubleshooting
Reviewing Cluster and Package States with the cmviewcl Command
Chapter 3 83
Viewing Data on Unowned Packages
The following example shows packages that are currently unowned, that
is, not running on any configured node. Information on monitored
resources is provided for each node on which the package can run; this
allows you to identify the cause of a failure and decide where to start the
package up again.
UNOWNED_PACKAGES
PACKAGE STATUS STATE AUTO_RUN NODE
PKG3 down halted enabled unowned
Policy_Parameters:
POLICY_NAME CONFIGURED_VALUE
Failover min_package_node
Failback automatic
Script_Parameters:
ITEM STATUS NODE_NAME NAME
Resource up manx /resource/random
Subnet up manx 192.8.15.0
Resource up burmese /resource/random
Subnet up burmese 192.8.15.0
Resource up tabby /resource/random
Subnet up tabby 192.8.15.0
Resource up persian /resource/random
Subnet up persian 192.8.15.0
Node_Switching_Parameters:
NODE_TYPE STATUS SWITCHING NAME
Primary up enabled manx
Alternate up enabled burmese
Alternate up enabled tabby
Alternate up enabled persian