Serviceguard Extension for RAC Version A.11.19 Release Notes, October 2009 (T1907-90051)

NOTE: If you are adding Serviceguard Extension for RAC to an existing Serviceguard
cluster, there are additional steps. See“Adding Serviceguard Extension for RAC to an
Existing Cluster”.
For more information, see:
• Managing HP-UX Software with SD-UX
• the swinstall (1M) manpage
Adding Serviceguard Extension for RAC to an Existing Cluster
If you have already installed Serviceguard and are running a Serviceguard cluster, use
the following steps to add SGeRAC:
NOTE: All nodes in the cluster must be either all SGeRAC nodes or Serviceguard
nodes. An SGeRAC cluster must have SGeRAC software installed on all nodes.
1. Halt the cluster.
2. Use swinstall to install SGeRAC on each node.
3. Modify the cluster configuration file as necessary for RAC use, add
OPS_VOLUME_GROUP if required, then run cmapplyconf.
4. Reboot each node.
5. Restart the cluster.
Compatibility Information and Installation 21