Serviceguard Extension for RAC Version A.11.18 Release Notes, 1st Edition, June 2007

Serviceguard Extension for RAC Version A.11.18 Release Notes
Compatibility Information and Installation Requirements
Chapter 1 25
For more information on either HP Serviceguard Cluster File System
version 5.0 for RAC (T2777CA) or HP Serviceguard Cluster File
System for RAC with MCOE (T2797CA), see the HP Serviceguard
Storage Management Suite Version A.02.00 Release Notes
(T2771-90036).
After installation, for example, use the following commands to display a
list of all installed components:
# swlist -R T1905BA
# swlist -R T1907BA
NOTE If you are adding Serviceguard Extension for RAC to an existing cluster
that is already configured with Serviceguard, there are additional steps.
See section “Adding Serviceguard Extension for RAC to an Existing
Cluster”.
For more information about installation procedures and related issues,
refer to the following manuals:
• Managing HP-UX Software with SD-UX, (B2355-90154)
• swinstall (1M) in the HP-UX Reference, (B2355-60105)
Adding Serviceguard Extension for RAC to an
Existing Cluster
If you have already installed Serviceguard and are running a
Serviceguard cluster, use the following steps to add SGeRAC:
NOTE All nodes in the cluster must be either all SGeRAC nodes or
Serviceguard nodes. SGeRAC cluster must have SGeRAC software
installed on all nodes.
1. Halt the cluster.
2. Use swinstall to install SGeRAC on each node.