Serviceguard Extension for RAC Version A.11.16 Release Notes, 2nd Edition, September 2004

Serviceguard Extension for RAC Version A.11.16 Release Notes Second Edition
Compatibility Information and Installation Requirements
Chapter 120
Removing Serviceguard Extension for RAC
To remove your software, run the SD-UX swremove command.
NOTE If you are removing SGeRAC and wish to continue using the cluster as
an Serviceguard cluster, there are slightly different steps. See “Removing
SGeRAC Without Removing Serviceguard”.
Use the following steps to remove the software from each node:
Online Node Reconfiguration:
NOTE For clusters with SLVM, all SLVM volume groups must be deactivated
from all nodes in the cluster. For clusters with CVM, there is no need to
deactivate volume groups from all nodes, just on the nodes to be
removed.
1. Halt the cluster services on the node(s) to be removed. Edit the
cluster ASCII file to remove the nodes from which you removed
Serviceguard Extension for RAC, then re-apply the configuration.
The cluster remains up and running.
2. Issue the swremove command to remove the software. If
Serviceguard Extension for RAC is being deinstalled from more than
one system, it should be removed from one system at a time.