Serviceguard Extension for RAC Version A.11.16 Release Notes, 2nd Edition, September 2004

Serviceguard Extension for RAC Version A.11.16 Release Notes Second Edition
Compatibility Information and Installation Requirements
Chapter 1 19
NOTE If you are adding SGeRAC to an existing cluster that has already
configured with Serviceguard, there are additional steps. See “Adding
Serviceguard Extension for RAC to an Existing Cluster” below.
After installation, you can use the following commands to display a list of
all installed components:
# swlist -R T1905BA
# swlist -R T1907BA
For more information about installation procedures and related issues,
refer to the following manuals:
• Managing HP-UX Software with SD-UX (B2355-90154)
• swinstall (1M) in the HP-UX Reference (B2355-90166)
Adding Serviceguard Extension for RAC to an
Existing Cluster
If you have already installed Serviceguard and are running a
Serviceguard cluster, use the following steps to add SGeRAC:
NOTE All nodes in the cluster must be either all SGeRAC nodes or
Serviceguard nodes. SGeRAC cluster must have SGeRAC software
installed on all nodes.
1. Halt the cluster.
2. Use swinstall to install Serviceguard Extension for RAC on each
node.
3. Modify the cluster configuration ASCII file as necessary for RAC use,
then run the cmapplyconf command.
4. Reboot each node.
5. Restart the cluster.