HP Serviceguard Enterprise Cluster Master Toolkit User Guide, December 2012 (5900-2145)

PARTITION_NUMBER 0
PARTITION_NUMBER 1
NOTE: Logical partitions of a database can be grouped to run in a single package while
physical partitions need separate packages for each.
Set the MONITOR_PROCESSES variable to process names, which must be monitored and
cleaned up to ensure fail safe shutdown of the DB2 Instance or Partition. The actual monitoring
is done by a command called db2gcf. The MONITOR_PROCESSES is only used to kill the
processes that remain alive after the shutdown of the database. By default, .db2sysc. is
configured in this variable. Repeat the variable to additional processes, if required. For
example,
MONITOR_PROCESSES db2sysc
Set the MAINTENANCE_FLAG variable to yes or no, to enable or disable the maintenance
mode feature for the package. For example,
MAINTENANCE_FLAG yes
Set the MONITOR_INTERVAL in seconds to specify how often the partition or instance is
monitored. For example,
MONITOR_INTERVAL 30
Set the TIME_OUT variable to the time that the toolkit must wait for completion of a normal
shut down, before initiating a forceful halt of the application. For example,
TIME_OUT 30
Set the monitored_subnet variables to the subnet that is monitored for the package.
Set the monitored_subnet_access variable to full if the subnet is available on all nodes,
otherwise, set it to partial.
monitored_subnet_access full
Set the variables for adding the package relocatable IP address. For example,
ip_subnet x.x.x.x
Set the ip_subnet_node to the node names where the subnet is valid. For example,
ip_subnet_node node1
ip_subnet_node node2
Set theip_address to a valid package IP. For example,
ip_address x.x.x.x
Create a separate vg variable for each volume group. For example,
vg vg_dd0
Create a separate fs_name, fs_directory, fs_type, and fs_mount_opt variables
for each database partition. For example,
fs_name /dev/vg_dd0/lvol1
fs_directory /dbpath/db2_payroll_inst/NODE0000
fs_type "ext3"
fs_mount_opt "-o rw"
fs_umount_opt ""
fs_fsck_opt ""
fs_name /dev/vg_dd0/lvol2
fs_directory /dbpath/db2_payroll_inst2/NODE0001
fs_type "ext3"
fs_mount_opt "-o rw"
82 Using the DB2 Database Toolkit in a Serviceguard Cluster in HP-UX