Continentalclusters Version A.07.01 release notes, August 2010 (T2346-90015)

with Continentalclusters version A.07.00, recovery groups using CVM disk groups can
be recovered by running the cmrecovercl command on any node in the recovery cluster.
Following are some of the other important changes in earlier versions of
Continentalclusters:
• If /etc/cmconcl/ccrac/ccrac.configfile is configured, you must specify
the CCRAC_CLUSTER parameter for every recovery pair in the ccrac.config
file. If you do not specify this parameter, the recovery process does not complete
and the following error message is displayed:
Cluster name is not specified as a set.
• When using TEXTLOG type notification, you must specify the destination log file
in the monitoring definition under/var/opt/resmon/log.
If you specify any other location for logging, the following error message appears:
The target after textlog ““ is not valid.
Please specify a file under /var/opt/resmon/log directory.
If you upgraded Continentalclusters but are still using the old configuration file,
the TEXTLOG location is still specified as /var/adm/cmconcl. As a result, the
following error message appears:
The file path “s” specified for textlog is invalid.
The destination file must be under /var/opt/resmon/log directory. Please
change the path and restart the ccmon package.
• The default eventlog is changed to /var/opt/resmon/log/cc/eventlog.
Prior to Continentalclusters A.06.00, this eventlog was under /var/adm/cmconcl/
eventlog.
Support for Serviceguard Features
Following Serviceguard features are not supported for packages configured in a
Continentalclusters Recovery Group.
• Modular style package when using pre integrated physical replication technologies
• Package dependency for failover packages
• Package maintenance mode
• Packages exclusion dependency
• Evaluation of package failover behavior using cmeval command.
Compatibility Information and Installation Requirements
The same version of Continentalclusters and Serviceguard must be installed on all
nodes in all the clusters of the configuration. To use Continentalclusters, the following
hardware and software must be installed and configured on all nodes.
Support for Serviceguard Features 9