Installation Guide, Sixth Edition - HP 9000 rp4410/rp4440

Installing the System

Powering ON and Powering OFF

Chapter 1

Step 2. Press the power button to start the server.

Step 3. Start the operating system.

Powering Off the Server

Power off the server using the following methods if the server is in the standby or full power state:

•iLO MP PC command

• Power button

Powering Off the Server Using the iLO MP PC Command

To power off the server using the iLO MP PC command, follow these steps:

Step 1. Gracefully shut down the operating system.

Step 2. Initiate a console session, and access the

MP Main Menu.

Step 3. Enter CM to enable command mode.

Step 4. Enter PC to use the remote power control command.

Step 5. Enter OFF to power off the server, and enter YES when prompted to confirm the action.

CAUTION The main dc voltage is now removed from the system; however, ac voltage for

standby power is still present in the server.

Step 6. Unplug all power cables from the receptacles on the rear panel of the server.

Powering Off the Server Manually

To manually power off the server, follow these steps:

Step 1. Gracefully shut down the operating system.

Step 2. Press the power button to power off the server.

CAUTION The main dc voltage is now removed from the system; however, ac voltage for

standby power is still present in the server.

Step 3. Unplug all power cables from the receptacles on the rear panel of the server.