Secure Path v2.0 for Sun Solaris Installation and Reference Guide

5-2 StorageWorks Secure Path Version 2.0 for Sun Solaris
Compaq Confidential – Need to Know Required
Writer: Cyndi Vaccaro Project: StorageWorks Secure Path Version 2.0 for Sun Solaris Comments:
Part Number: AA-RKYDA-TE File Name: f-ch 5 Managing Secure Path .doc Last Saved On: 12/21/99 4:08 PM
Secure Path Management Tool (spmt)
Table 5-1 lists the command options for spmt. Each option is described on the
following pages.
Table 5-1
spmt Command Options
Commands Action(s)
display Displays status and information about Secure Path devices.
cli
Invokes a command line interpreter (CLI) session to the RAID
controller.
toggle Switches the I/O to the standby path.
restart Sends a CLI RESTART command to a specified controller.
shutdown
Sends a CLI SHUTDOWN command to a specified controller
.
restore Restores a Secure Path device to its preferred path.
remove Quiesces paths for a specified HBA.
reconfig Activates paths for a specific HBA.
spmt Commands
spmt display
The spmt display command displays information about Secure Path devices,
including the controllers, paths, and host bus adapters used by that Secure Path
device.
The spmt display command has the form:
# spmt display -t target_number
where:
Default displays information and status for all Secure Path devices.
target_number is the Secure Path target assigned to the storage unit.