Secure Path v2.0 for Sun Solaris Installation and Reference Guide

Installing Secure Path Software 4-3
Compaq Confidential – Need to Know Required
Writer: Cyndi Vaccaro Project: StorageWorks Secure Path Version 2.0 for Sun Solaris Comments:
Part Number: AA-RKYDA-TE File Name: e-ch4 Installing Secure Path Software.doc Last Saved On: 12/21/99 5:18 PM
b. Check that the volume manager has automatically mounted the CD-
ROM, by entering:
# mount
NOTE: The system command may take a few seconds to mount the CD-ROM. If the
mount command does not indicate that the CD-ROM has been mounted, wait a short
interval and then repeat the command. The volcheck command may be used to force vold
to check for mounted media.
c. Change to the Solaris directory. Enter:
# cd /cdrom/sp_v20_sun/solaris
d. Continue with step 3.
If vold is not currently running, then:
a. Insert the CD-ROM into the CD-ROM drive.
b. Mount the CD-ROM. For example, enter:
# mount – f hsfs – r /dev/dsk/c0t6d0s2 /cdrom
c. Change to the Solaris directory, enter:
# cd /cdrom/sp_v20_sun/solaris
d. Continue with step 3.
3. Install Secure Path software (CPQswsp) on the Sun Solaris server(s).
The Secure Path software is installed using the Solaris “pkgadd” utility.
Enter:
# pkgadd – d pkgs
NOTE: The following steps apply only after the Secure Path configuration utility has been
run successfully, as described in the in the Secure Path Configuration Tool section of this
chapter.
4. Reboot the server(s).
5. Verify the Secure Path configuration by running the Secure Path
Maintenance Tool.