Secure Path v2.0 for Sun Solaris Installation and Reference Guide

Secure Path (Fibre Channel) Installation 3-7
Compaq Confidential – Need to Know Required
Writer: Cyndi Vaccaro Project: StorageWorks Secure Path Version 2.0 for Sun Solaris Comments:
Part Number: AA-RKYDA-TE File Name: d-ch3 FC Installs.doc Last Saved On: 12/21/99 5:05 PM
6. Power on the server.
7. Boot the system using the reconfiguration switch as follows:
For Solaris 2.6: ok> boot –r
NOTE: Secure Path v2.0 for Sun Solaris is only supported in 32-bit kernel mode.
For Solaris 2.7: ok> boot kernel/unix -r
NOTE: Secure Path installation requires that at least one disk device with two paths is
configured on the RA8000/ESA12000 system.
8. Install or reinstall the RA8000/ESA12000 Solution Software V8.5 for
Solaris 2x and configure the fibre channel drivers for loop mode.
NOTE: Refer to the RA8000/ESA12000 HSG80 Solution Software V8.5 for Sun Solaris –
Installation Reference Guide for detailed Solution Software configuration information,
including SWCC Agent and arbitrated loop.
9. Check to ensure that each connection has an offset of 0 and that its
operating system is set to SUN, using the following commands:
a. To inspect the connection settings, enter:
HSG80 > show connections
Example “show connections” output:
Connection Unit
Name Operating system Controller Port Address Status Offset
!NEWCON32 SUN THIS 2 000001 OL this 0
HOST_ID=1000-00E0-6940-123C ADAPTER_ID=2000-00E0-6940-123C
!NEWCON34 SUN OTHER 2 000001 OL other 0
HOST_ID=1000-00E0-6940-11A8 ADAPTER_ID=2000-00E0-6940-11A8
b. To set the operating system:
HSG80 > set (connection name) operating_system = sun
c. To set the offset, if necessary:
HSG80 > set (connection name) unit_offset = 0
System is now ready for the installation of the Secure Path Software in
Chapter 4.