HP StorageWorks Secure Path V3.0C for Linux and Linux Workgroup Edition Installation and Reference Guide (AA-RU7VD-TE, February 2004)

Removing/Upgrading Secure Path
95Secure Path v3.0C for Linux and Linux Workgroup Edition Installation and Reference Guide
For Red Hat operating systems:
Insertion point found in /etc/rc.d/rc.sysinit
Removal of Secure Path complete.
Please reboot system to unload Secure Path modules.
Note: If the RAID storage system is to be used for single-path access by one or more
servers, then the HSG80 dual-redundant controllers must be restored to Transparent
Failover mode. Refer to “HSG80 Controller Failover Transitions” on page 105 to
perform the transition to Transparent Failover mode.
Refer to MSA1000 documentation to set MSA1000 to single-path mode.