HP StorageWorks Secure Path V3.0C for Linux and Linux Workgroup Edition Installation and Reference Guide (AA-RU7VD-TE, February 2004)

Installing Secure Path Software
45Secure Path v3.0C for Linux and Linux Workgroup Edition Installation and Reference Guide
Installing Secure Path
Secure Path installation has been automated to use the Red Hat Package
Management (RPM) utility installation.
If the installation process cannot complete for any reason, you will be instructed
how to proceed manually. Every effort has been made to make your Secure Path
software installation as simple and straightforward as possible, but given the large
variations possible in system setup, manual intervention may be required.
Manually installing Secure Path
Secure Path v3.0C is installed based upon your operating system parameters. The
following sections break down the installations in the following order:
1. Machine type: 32-bit or 64-bit
2. Full installation or Workgroup Edition
3. Red Hat or SUSE/UnitedLinux (64-bit only)
Install Secure Path software by performing the following procedures:
Caution: For each RAID system in a production environment that is being
converted to Secure Path operation, make sure that all users have logged off
the Linux servers and that all I/O to the RAID systems has ceased. Follow
normal procedures to back up the storage systems before proceeding.
1. Insert the Secure Path v3.0C CD-ROM into the CD-ROM drive. A sample
command follows:
# mount /dev/cdrom /mnt/cdrom
2. Change to the RPM directory. For example:
# cd /mnt/cdrom/RPM
You should be in the directory of the installation software RPM.