HP StorageWorks Secure Path V3.0C for Linux and Linux Workgroup Edition Installation and Reference Guide (AA-RU7VD-TE, February 2004)

Installing Secure Path Software
44 Secure Path v3.0C for Linux and Linux Workgroup Edition Installation and Reference Guide
Installation prerequisites
Note: HSG80 controllers are not supported with 64-bit machines.
Before installing Secure Path v3.0C, verify the following requirements:
■ The prerequisites listed in the HP StorageWorks Secure Path v3.0C for Linux
Release Notes have been met.
■ The procedures in “Hardware Setup” on page 29 have been performed.
■ At least one unit is configured on the RAID storage system and is visible to
the server from at least two paths. Ideally, and strongly recommended, the
RAID storage systems should be configured with all the desired storagesets
and units.
■ For the EVA3000/EVA5000/HSG80—A supported QLA2300 driver must be
installed. Ensure that you have installed the latest driver kit. Driver kits are
available at
http://h18006 .www1.hp.com/products/storagew orks/fca2214dc/inde x.html .
■ For the MSA1000—A supported QLA2300 driver must be installed from the
MSA1000 solution software CD and must recognize the LUNs on your
MSA1000. For more MSA1000 information, access the following web site at:
http://www.hp.com/go/msa1000.
■ Ensure that you have successfully installed and configured the storage system
hardware and software per the instructions that came with your storage
system.