HP StorageWorks Secure Path V3.0C for Linux and Linux Workgroup Edition Installation and Reference Guide (AA-RU7VD-TE, February 2004)

Hardware Setup
41Secure Path v3.0C for Linux and Linux Workgroup Edition Installation and Reference Guide
4. Verify that the correct WWPNs have been mapped to targets using the
following command. The correct WWPN is shown in the output displayed on
line 2.
Note: This example shows only partial output from the command.
CLI> show this
After you install the Solution Software and the WWPNs have been mapped to
targets, you are prompted to reboot your system with the reconfigure flag.
Note: Refer to the Solution Software for Linux – Installation Reference Guide for
detailed Solution Software configuration information, including fabric instances of the
WWPNs.
5. Use the following command to reboot your system:
# reboot
Host PORT_1: 1.
Reported PORT_ID = 5000-1FE1-0000-8923 2.
PORT_1_TOPOLOGY = FABRIC (fabric up) 3.
Address = 021000 4.
Host PORT_2: 5.
Reported PORT_ID = 5000-1FE1-0000-8924 6.
PORT_2_TOPOLOGY = FABRIC (fabric up) 7.