HP StorageWorks Secure Path V3.0C for Linux and Linux Workgroup Edition Installation and Reference Guide (AA-RU7VD-TE, February 2004)

Hardware Setup
39Secure Path v3.0C for Linux and Linux Workgroup Edition Installation and Reference Guide
Connecting storage to the server
This section describes how to connect configured storage to your server. For more
information on supported configurations, access the HP web site at:
http://hp.com/country/us/eng/prodserv/storage.html .
1. Cable the Fibre Channel adapter and the RAID storage system controllers to
the SAN Switches and HBAs, as shown in Figure 3.
2. Choose from the following options:
a. Proceed to “Installing Secure Path Software” on page 43 to install Secure
Path if all the storage systems that you are configuring are
EVA5000/EVA3000 or RA8000/EMA12000 arrays in SCSI-3 CCL
mode.
b. Map WWPNs to targets as shown in step 3 through step 5 if you have any
HSG80-based storage using SCSI-3 CCL mode.
Note: You must map WWPNs before installing Secure Path as described in “Installing
Secure Path Software” on page 43.