Release Notes HP StorageWorks Secure Path 3.0F Service Pack 4 for HP-UX 11i v1.0 and 11i v2.0 (5697-8002, March 2009)

Interoperability with Ignite-UX software
Ignite-UX software does not support Secure Path 3.0F SP4 for the following reasons:
• When Secure Path 3.0F SP4 is installed on a system, the hardware addresses of all EVA disk
LUNs change. During the recovery process, importing LVM volume groups on the EVA array may
fail.
• If the boot disk resides on an EVA array, the system fails to boot due to an LVM configuration
failure.
• Secure Path 3.0F SP4 is not included in the installation kernel and is not part of the core HP-UX
operating system.
Secure Path 3.0F SP4 for Active-Active disk arrays
This section describes the following topics:
• Whats new with Secure Path 3.0F SP4 for Active-Active disk arrays
• Operating system support
• Avoiding problem situations
What's new with Secure Path 3.0F SP4 for Active-Active disk arrays
Secure Path 3.0F SP4 for Active-Active disk arrays provides the following features and fixes:
• Provides support for Logical Units presented from HP StorageWorks disk arrays
EVA6400/EVA8400.
• An issue where the path status of LUNs not updating accurately on recovery from all path failure
condition during heavy I/O load, has been resolved.
Operating system support
Table 4 lists the system features and requirements for Secure Path 3.0F SP4 for Active-Active disk
arrays. For additional support information, see the HP website:
http://www.hp.com/support
Table 4 Secure Path 3.0F SP4 for Active-Active disk arrays system features and requirements
RequirementSystem feature
HP-UX 11i v1.0 (64–bit)
HP-UX 11i v2.0
HP-UX version
PA-RISC and Integrity serverHP-UX server system types
EVA4x00
EVA6x00
EVA8x00
XP10000
XP12000
XP20000
XP24000
Supported storage arrays
HP StorageWorks Secure Path 3.0F Service Pack 4 for HP-UX 11i v1.0 and 11i v2.0 19