Installation and Reference Guide HP StorageWorks Secure Path 3.0F Service Pack 4 for HP-UX 11i v1.0 and 11i v2.0 (5697-8001, March 2009)

Syslog messagesUser notification messagesEvent description
CPQswsp: Persistence error.
Cause: Insufficient system
memory. Failed to retrieve
the persistent data for the
Array 50001FE150 003440.
This may result in loss of
Secure Path configuration
settings for this Array.
Also this may result in the
change of c#t#d# values of
the LUNs configured on this
Array
CPQswsp: Persistence error.
Cause: Insufficient system
memory. Failed to re-
trieve/update the persist-
ent data.May result in
change/loss of Secure Path
configuration/device set-
tings across system re-
boots.
Occurs when there is a failure to
retrieve the persistent data of an
array (like load balancing, path
verification, path verification
period, auto-restore) or a failure
while retrieving the persistent
data of the swsp interface nodes
of the array.
CPQswsp: Persistence error.
Cause: Insufficient system
memory.Failed to retrieve
the persistent data for the
Array 50001FE150 003440.This
may result in loss of Secure
Path configuration settings
for this Array
CPQswsp: Persistence error.
Cause: Insufficient system
memory. Failed to re-
trieve/update the persist-
ent data.May result in
change/loss of Secure Path
configuration/device set-
tings across system re-
boots.
Occurs when there is a failure in
retrieving the persistent data of
an array (like load balance, path
verification, path verification
period, auto-restore) during boot.
CPQswsp: Persistence error.
Cause: Insufficient system
memory. Failed to retrieve
the persistent data for the
Array 500 01FE150003440.
This may result in the
change of c#t#d# values of
the LUNs configured on this
Array. Ignore this message
if all the LUNs of this Ar-
ray are deleted
CPQswsp: Persistence error.
Cause: Insufficient system
memory. Failed to re-
trieve/update the persist-
ent data.May result in
change/loss of Secure Path
configuration/device set-
tings across system re-
boots.
Occurs when there is a failure to
retrieve the persistent data of the
swsp interface nodes of the array
during boot.
CPQswsp: Persistence error.
Cause: Insufficient system
memory. Failed to retrieve
the persistent data for the
LUN 600508B400
01492000016000005B0000. The
LUN will be in unmapped
state till it is configured
using 'spmgr add' followed
by 'ioscan'
CPQswsp: Persistence error.
Cause: Insufficient system
memory. Failed to re-
trieve/update the persist-
ent data.May result in
change/loss of Secure Path
configuration/device set-
tings across system re-
boots.
Occurs when there is a failure
retrieving the persistent data of
the LUN during boot.
CPQswsp: Persistence error.
Cause: Insufficient system
memory. Failed to re-
trieve/update the persistent
data.May result in
change/loss of Secure Path
configuration/device set-
tings across system reboots
CPQswsp: Persistence error.
Cause: Insufficient system
memory. Failed to re-
trieve/update the persist-
ent data.May result in
change/loss of Secure Path
configuration/device set-
tings across system re-
boots.
Indicates there is a failure in set-
ting or retrieving the persistent
data in kernel.
Secure Path for Active-Passive disk arrays74