Installation and Reference Guide HP StorageWorks Secure Path 3.0F Service Pack 4 for HP-UX 11i v1.0 and 11i v2.0 (5697-8001, March 2009)

The previous commands must be executed from the server on which Secure Path for Active-Passive
array is installed and is to be managed.
Remote spmgr execution
To execute remote management, enter the following command:
spmgr remote_host:command_name
Example:
# spmgr xyz.hp.com:display
The spmgr remote_host:command_name command executes the specified command on the
system on which Secure Path for Active-Passive disk arrays is installed, and displays information on
the remotely managed host.
You can execute the following commands remotely:
• add
• clean
• delete
• display
• log
• prefer
• quiesce
• refreshdisplay
• restart
• restore
• select
• set
• unprefer
You cannot execute the following commands remotely:
• alias
• client
• notify
• passwd
• unalias
Removing and upgrading Secure Path for Active-Passive disk
arrays
This section describes how to remove or upgrade Secure Path for Active-Passive disk arrays, including:
• Removing Secure Path
• Upgrading Secure Path software
HP StorageWorks Secure Path 3.0F Service Pack 4 for HP-UX 11i v1.0 and 11i v2.0 69