Installation and Reference Guide HP StorageWorks Secure Path 3.0F Service Pack 4 for HP-UX 11i v1.0 and 11i v2.0 (5697-8001, March 2009)

Table 10 describes terms that have special meaning for the spmgr command.
Table 10 spmgr terms
DescriptionTerm
Refers to using spmgr to add a LUN or all LUNs of an array to the Secure Path for
Active-Passive configuration
Add
Refers to using spmgr to remove a LUN or all LUNs of an array from the Secure Path
for Active-Passive configuration
Delete
Refers to using the StorageWorks array utilities to add a unit or virtual disk so that the
server or host can see it
Present
Refers to using the StorageWorks array utilities to remove a unit or virtual disk so that
the server or host cannot see it
Unpresent
Adding LUNs
The spmgr add command provides the following options:
• # spmgr add WWLUNID
• # spmgr add –r WWNN all
During installation, all HSG80 units and HSV110 virtual disks that are presented to the server are
added and attached by Secure Path for Active-Passive disk arrays.
Complete the following steps to add storage after installation:
1. Present the units or virtual disks to the storage system.
2. Run ioscan to add and attach the new storage.
3. Run insf to install and assign device files.
NOTE:
The spmgr add command is not required for adding new storage.
To add units or virtual disks that have been previously deleted using spmgr delete and are displayed
in the spmgr display -u list of unattached devices, complete the following steps:
1. Run spmgr add to add the LUNs to Secure Path for Active-Passive disk arrays.
2. Run ioscan to claim the LUNs.
3. Run insf to install and assign device files.
NOTE:
To configure a LUN under Secure Path during new LUN discovery or during the spmgr add, resources,
c#t#d# value, and system memory must be available. If any of these resources are not available,
the LUN will be in an unmapped state and is displayed as part of the unattached list. To map these
LUNs and to add them to the Secure Path active list, ensure that the resources are available and you
run ioscan.
HP StorageWorks Secure Path 3.0F Service Pack 4 for HP-UX 11i v1.0 and 11i v2.0 63