Installation and Reference Guide HP StorageWorks Secure Path 3.0F Service Pack 4 for HP-UX 11i v1.0 and 11i v2.0 (5697-8001, March 2009)

This section describes the following:
• # spmgr display
• # spmgr display -a[v] HBA
• # spmgr display -c[v] controller_serial_number
• # spmgr display -d[v] device_instance
• # spmgr display –p path_instance
• # spmgr display –r[v] WWNN
• # spmgr display -s
• # spmgr display -u
• # spmgr refreshdisplay
# spmgr display
When you enter the spmgr display command, all information for the entire configuration is
displayed. The amount of information displayed depends on the number of HBAs, storage systems,
and paths to a unit on each storage system.
The full display derives from the component portions described in this section. You can limit the amount
of data displayed by combining the spmgr display command with one of the described switches.
Example:
# spmgr display
Server: hp.mydomain.com Report Created: Thu, Sep 13 16:11:50
2004
Command: spmgr display
= = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =
Storage: 5000-1FE1-0010-5B00
Load Balance: Off Auto-restore: Off
Path Verify: On Verify Interval: 30
HBAs: td0 td1
Controller: ZG10505167, Operational
ZG10506981, Operational
Devices: c16t0d0 c16t0d1
TGT/LUN Device WWLUN_ID H/W_Path #_Paths
0/ 0 c16t0d0 6000-1FE1-0010-5B00-0009-1050-6981-0013 4
0/0/255.0.0.0
Controller Path_Instance HBA Preferred? Path_Status
ZG10505167 no
c4t0d0 td0 no Standby
c10t0d0 td0 no Standby
Controller Path_Instance HBA Preferred? Path_Status
ZG10506981 no
c5t0d0 td0 no Active
c11t0d0 td1 no Available
TGT/LUN Device WWLUN_ID H/W_Path #_Paths
0/ 1 c16t0d1 6000-1FE1-0010-5B00-0009-1050-6981-0014 4
0/0/255.0.0.1
Controller Path_Instance HBA Preferred? Path_Status
ZG10505167 no
c4t0d1 td0 no Standby
c10t0d1 td1 no Standby
Controller Path_Instance HBA Preferred? Path_Status
ZG10506981 no
c5t0d1 td0 no Active
c11t0d1 td1 no Available
Secure Path for Active-Passive disk arrays42