Installation and Reference Guide HP StorageWorks Secure Path 3.0F Service Pack 4 for HP-UX 11i v1.0 and 11i v2.0 (5697-8001, March 2009)

DescriptionOptions or argumentsCommand
Refreshes the array controller serial numbers
NOTE:
Only the controller serial number is updated
and not the controller status. This is because
the controller status is determined by the status
of the paths going through that controller.
no argument
spmgr
refreshdisplay
Returns a previously quiesced object to an active,
available, or standby state
-a adapter
-c controller_ser_num
-p path_instance
all
spmgr restart
Restores one or more devices to their preferred
I/O path
-d device
-r WWNN
all
spmgr restore
Selects a path or controller for I/O. Also, initiates
a LUN movement if necessary
-c controller_ser_num [-d device]
-p path_instance
spmgr select
Enables or disables Secure Path features like load
balancing, path verification
-a on | off WWNN
-b on | off | rr | lb | li | ls |
WWNN
-f interval
-p on | off WWNN
spmgr set
Removes an aliasalias_name old_name
spmgr unalias
Removes a preferred path attributepath_instance
spmgr unprefer
NOTE:
Commands entered without an argument respond with usage if the command is a configuration
altering command. The commands alias, display, log, and notify respond with current
command or configuration information.
The changes to the configuration settings performed by the following commands are persistent across
system reboots and Secure Path upgrades:
• spmgr add
• spmgr clean
• spmgr delete
• spmgr log
• spmgr prefer
• spmgr set
• spmgr unprefer
The changes to the configuration settings performed by the following commands are persistent across
system reboots but not persistent across Secure Path upgrades:
HP StorageWorks Secure Path 3.0F Service Pack 4 for HP-UX 11i v1.0 and 11i v2.0 37