Installation and Reference Guide HP StorageWorks Secure Path 3.0F Service Pack 4 for HP-UX 11i v1.0 and 11i v2.0 (5697-8001, March 2009)

• The manual pages for spmgr, spagent, spinit, hsx, and swsp.
If you are using StorageWorks Command Console (SWCC) to manage an HSG80 environment, all
devices that existed prior to the install are now hidden behind the hsx and swsp drivers, and new
names are presented to the sdisk SCSI class driver.
To update the new device names, complete the following procedure:
1. Execute the ioscan command to determine the new device names.
2. Refer to the HSG80 ACS Solution Software for HP-UX installation and configuration guide and
perform the following procedures:
a. Modify the access device with the new name.
b. Enable the option to start the agent during system boot.
c. Restart the agent.
Installing Secure Path on a SAN boot device
Secure Path 3.0F SP4 supports SAN boot from an EVA LUN on HP-UX 11i v1.0 and 11i v2.0. This
includes providing high availability to the SAN boot LUN. Support for the SAN boot is provided only
if the root volume group is configured using Logical Volume Manager (LVM).
Secure Path 3.0F SP4 also supports the Dump and Swap devices configured on an EVA LUN on HP-UX
11i v1.0 and 11i v2.0.
This section describes the following:
• Prerequisites
• Installation steps
• Limitations
Prerequisites
You must perform the following tasks before installing Secure Path on a SAN boot device:
• Ensure that there are at least two paths to the active controller of the EVA disk array.
• Ensure that the connectivity to the standby controller for the EVA boot LUN is disabled.
• Install Hardware Enablement Bundle March 2003 (or later) before installing Secure Path for 11i
v1.0.
Installation steps
To install Secure Path on a SAN boot device, follow the steps below:
1. Install HP-UX 11i v1.0 and 11i v2.0 on an EVA LUN.
2. See the HP StorageWorks Secure Path 3.0F Service Pack 4 for HP-UX 11i v1.0 and 11i v2.0
release notes to verify that all required patches are installed.
NOTE:
The system reboots automatically after the patch installation.
3. Install Secure Path 3.0F SP4.
The system reboots after the installation completes.
Secure Path for Active-Passive disk arrays34