Managing HP Serviceguard Extension for SAP for Linux (May 2013)

deploysappkgs combi C11

deploysappkgs multi C11

This command attempts to create either a minimal (combi = combine instances) or a maximum

(multi = multiple instances) number of packages. If suitable base packages are already created in

Phase 1, it extends those packages with the necessary attributes found for the installed C11 instance.

If necessary, the configuration file for the enqor multi-node package is also created. You must

review the resulting configuration files before applying them. Depending on the attributes changed

or added, cmapplyconf command might fail, and stop running packages.

NOTE:

• To get complete package configurations it is recommend that SAP database and instances

are running on the node where deploysappkgs is invoked. Otherwise, attributes (especially

regarding the filesystem and volume_group module) might be missing.

• deploysappkgs can also be invoked at the end of Phase2 on the primary node. However,

the created package configurations cannot be applied yet.

Creating SGeSAP package with guided configuration using Serviceguard Manager

NOTE: To create a package you can use either Serviceguard Manager GUI or the CLI. This

section describes GUI steps and the CLI steps are described in the “Creating SGeSAP package

with CLI” (page 66) section.

1. Startup the Servicegurad Manager and add the SGeSAP modules to the existing base

packages, if they are not added in Phase 1.

2. Update the SGeSAP attributes with the current values, if the SGeSAP modules are already

added in Phase 1.

Creating SGeSAP package with CLI

NOTE: To create a package you can use either Serviceguard Manager GUI or the CLI. This

section describes CLI steps and the GUI steps are described in the “Creating SGeSAP package

with guided configuration using Serviceguard Manager” (page 66) section.

The SGeSAP configuration must be added to the Serviceguard “base” packages created earlier,

if they are not added in Phase 1.

An example for adding or updating the package using the command line is as follows:

1. Run the mv <pkg>.config<pkg>.config.SAVE command to add sapinstance module

to an existing package.

2. Run the cmmakepkg –m sgesap/sapinstance -i <pkg>.config.SAVE

<pkg>.config command

3. Run the mv <pkg>.config<pkg>.config.SAVE command to add dbinstance module

to an existing package.

4. Run the cmmakepkg –m sgesap/dbinstance -i <pkg>.config.SAVE

<pkg>.config command

5. Edit the package configuration file to update the relevant SGeSAP attributes.

NOTE: Non SGeSAP attributes such as service or generic_resource must also be

updated.

6. Run the cmapplyconf –P <pkg>.config command to apply the configuration.

7. Run the cmrunpkg <pkg> command to start the package.

66 Clustering SAP using SGeSAP packages