HP StorageWorks SAN Virtualization Services Platform Data Path Module User Guide (5697-0772, November 2010)

3. Log in to the DPM with the default login and password.
NOTE:
HP recommends that you change the default password. If you have not already done so,
run the “Modify user command” on page 42 to change the password.
login: admin
password: password
The following menu options are displayed (see Figure 3).
Figure 3 PuTTYtel console menu options
.
4. Enter commands from the command line to begin managing the DPM with the CLI commands.
Users and groups
The DPM provides two built-in users and two built-in groups: admin is a member of the Administrator
group, and kmonitor is a member of the Monitor group.
Table 2 shows the default password for both accounts. See “Modify user command” on page 42 for
information about changing the password.
NOTE:
The default passwords may have been changed prior to your installation of the DPM. See the records
of the installation for details.
Users in the Monitor group are limited to commands that only view system configuration and status;
Monitor users cannot change the system configuration. See the show commands, such as “Show user
command” on page 65, “Show port command” on page 59, and so on, for more information.
Users in the Administrator group can create and delete users, and they can also modify users, eths,
ports, and perform all of the other commands listed in this document. See “Create user
command” on page 19, “Delete user command” on page 22, “Modify user command” on page 42,
HP StorageWorks SAN Virtualization Services Platform Data Path Module User Guide 15