HP StorageWorks SAN Virtualization Services Platform 3.0.2 Release Notes (5697-0347, May 2010)

Fixes
The following issue was fixed in HP StorageWorks SAN Virtualization Services Platform from version
3.0.1 to version 3.0.2:
• Resolved a timeout issue when trying to access an object without permission (for example, Add
permission to a VDisk) and the user was logged off the HP Command View SVSP GUI. The fix
was in the WebServer (flag changes).
Prerequisites
A dual-fabric SAN as defined by the HP SAN Design Reference Guide (http://www.hp.com/go/
SANDesignGuide), with approved storage arrays using B- or C-series switches. See the HP Single
Point of Connectivity Knowledge (SPOCK) website at http://www.hp.com/storage/spock for supported
switch firmware. Site registration is required.
Enhancements
This release introduces the HP StorageWorks Command View SVSP GUI as an optional method of
managing the solution.
Installation instructions
For a new or upgrade installation of Virtualization Services Manager or Data Path Module software,
contact HP Support. After installing the VSM GUI, change the registry as described below and reboot
the VSM server.
At the location HKEY_LOCAL_MACHINE\System\CurrentControlSet\Control\
CrashControl\CrashDumpEnabled, set the registry key to 0x1 (instead of 0x2).
Host operating systems and multipath drivers
Table 1 lists the SVSP 3.0.2 supported and non-supported operating systems. See http://www.hp.com/
storage/spock for a listing of supported operating systems and required multipath drivers. Site
registration is required. Also see “Operating system issues” on page 12 for issues with supported
operating systems.
4