HP StorageWorks Reference Information Storage System V1.1 Administrator Guide (February 2005)

LO
Chapter 2: Platform Control Center Services tools folder
2-116 HP StorageWorks Reference Information Storage System Administrator Guide, February 2005
2. Find smart cell’s smart cell group identification number. Replicas are
designated by the first letter in the smart cell group identification
number:
– R1 (primary replica)
– R2 (secondary replica)
Restoring data on failed smart cells
To restore data on a failed smart cell, you must have at least one free smart
cell. If only one smart cell in a group failed, clone a smart cell instead (see
Smartcell Cloning view , on page 2-36).
To restore a smart cell, the following must occur:
• Its domain has DataBackupEnabled=true set in the Domain.jcml configuration
file.
• Its group was assigned in this system at one time.
• It is marked as missing in the ViewCellState table or no record exists in
the
ViewCellState table.
Note: Rebuilding the index on the smart cell takes a significant amount
of time depending on the amount of data being restored.
If both smart cells in a group failed, perform the following:
1. In the
View Cell Space view, scroll to the Unaffiliated SmartCells area, and
verify that at least one free smart cell exists.
2. Locate the primary controller:
a. Under
MetaServer , click the link to the primary or main controller
(metaserver). The
Agent view appears.
b. From the
MBean list, click ProvisionerMBean . The MBean view appears.
c. Verify the
ProvisionerMasterBackupStatus attribute is set to Master
Provisioner
. If it is set to Backup Provisioner , return to the View Cell Space
view, click the link to the other metaserver, and repeat the previous
steps.