ColorSpan Legacy System Control - User Guide
RIP Saver 2-27
Saving a RIP File
Use one of the following methods to save a job to a RIP Saver
queue:
◆
Route a port to send all files that come through it to a RIP
Saver queue.
◆
Route a document so that it goes to a RIP Saver queue.
◆
Drag the file from an Output queue to a RIP Saver queue.
For more information about routing, see “Routing Jobs” on page
2-6.
Note
When a document resides in a
RIP Saver
queue, you can
only change comments and number of copies, or change
the media (if the file was RIPed in SmoothTone Full Page
or Mural modes).
Printing a RIP Saver File
To print a document from a RIP Saver queue, select and drag it
to the desired Output queue. Remember that you can only print
the document on the type of printer for which it was processed.
Archiving RIP Saver Files
To archive a document from a RIP Saver queue, select and drag it
to an external device. For more information about external disk
drives, see the section “External Disk Drives” on page 2-28.