ColorSpan Legacy System Control - User Guide
A-10 Problems and Solutions
Macintosh Networking Print Server Not Appearing In Chooser On Ethernet
Make sure that:
◆
EtherTalk,
not LocalTalk
, is chosen using the Network Control
Panel.
◆
The Macintosh is configured for EtherPhase2 protocol
(not
Phase1)
in the Extensions folder.
◆
You have not changed the cabling without restarting the
server.
◆
If you use 10BASE-2, make sure the coax cable is connected
to a terminated T-Connection, which is then connected to
the print server port.
If this still does not work, follow these steps:
1. Toggle the AppleTalk Active/Inactive selection in the
Chooser.
2. Turn off voice recognition if you use a Quadra 660/AV or
840/AV.
3. Reload the networking software from Apple's System soft-
ware installation disks.
4. If you use 10BASE2, try a longer cable (longer than 12
feet).
5. Press Command-Option-R-P when rebooting to clear the
parameter RAM and force the Macintosh to retrieve the
AppleTalk zone names from the network.
6. Try connecting a cable to the server that works with
another device on the network. This will isolate any cable
problems.