HP XP24000/XP20000 Virtual LVI/LUN (VLL) and Volume Shredder User Guide (T5214-96094, November 2011)

d. Click Set to display the setting in the How to create volume table. To remove VLL volume
settings displayed in the How to create volume table, do the following:
• To remove a setting, select the VLL volume, and click Delete. When a confirmation
message appears, click OK.
• To remove all settings, click Clear. When a confirmation message appears, click
OK.
e. To set other VLL volumes, repeat steps a through d. After setting all VLL volumes, go to
step 7.
6. For non-OPEN-V, do the following on the Make Volume dialog box (1):
a. In the Capacity field, enter the capacity of the VLL volume you want to create, either in
MB or blocks for open systems or in cylinders (Cyl) for mainframe volumes. The available
capacity range (minimum - maximum) is shown to the right of the Capacity field. The value
can be incremented by 1 MB or 1 block for open systems or by 1 Cyl for mainframe
systems.
b. Click Set to display the setting in the How to create volume table. To remove VLL volume
settings displayed in the How to create volume table, do the following:
• To remove a setting, select the VLL volume, and click Delete. When a confirmation
message appears, click OK.
• To remove all settings, click Clear. When a confirmation message appears, click
OK.
c. To create other VLL volumes, repeat steps a through b. After setting all VLL volumes, go
to step 7.
7. Click Next to display the Make Volume dialog box (2).
8. On the Make Volume dialog box (2), select one or more VLL volume numbers to assign an
LDKC number, a CU number, and an LDEV number.
9. Select a CU number from the Select CU No. list.
10. Select an LDEV number from the white LDEV numbers in the Select LDEV NO. table. Gray
indicates LDEV numbers that are not selectable, white indicates unused LDEV numbers, and
blue indicates available LDEV numbers. The LDEV number, CU number, and LDEV number
appear in the LDKC:CU:LDEV field of the VLL volume-setting information table on the Make
Volume dialog box (2).
You cannot specify an LDEV number if free LDEV numbers in LUSE configuration are not
available in either of the following CUs:
• The CU displayed in Select CU No.
• A CU whose CU number is larger than the CU number displayed in Select CU No.
11. Repeat steps 8 through 10 to set other VLL volumes.
12. To remove an LDKC:CU:LDEV number that is already assigned, select one or more VLL volume
numbers corresponding to the LDKC:CU:LDEV numbers that you want to remove, and then
right-click and select Clear.
13. After setting all CU numbers and LDEV numbers, click Next. If the boundary area of the selected
LDEV number does not have an SSID, the SSID setting dialog box appears. Go to step 14. If
the boundary area of the selected LDEV number has an SSID, go to step 19.
14. On the SSID setting dialog box, select the CU number.
15. Select a new SSID in the Input SSID list. If you have logged in as a storage administrator and
the SSID number of another SLPR is used, check box is selected, you can also enter an SSID
in the Input SSID list.
16. Click Set. The SSID is displayed in the SSID field of the SSID setting area.
17. To set two or more SSIDs, repeat steps 14 through 16.
18. After setting all SSIDs, click Next. A dialog box appears.
Virtual LVI/LUN Operations 69