HP XP24000/XP20000 Snapshot User Guide (T5213-96033, November 2011)

Table 34 Cause of Error and the Result of RAID Manager Command (SSB) (continued)
Cause of ErrorRAID Manager CommandSSB2SSB1
XP Snapshot S-VOL, the
command ends abnormally.
Since you specified the XP
Business Copy reserved
All commands975c
volume as the XP Snapshot
S-VOL, the command ends
abnormally.
Since you specified the XP
Auto LUN source volume as
All commands975d
the XP Snapshot S-VOL, the
command ends abnormally.
For information about using
XP Auto LUN, contact HP
technical support (see
(page 110)).
Since you specified the XP
Auto LUN target volume as
All commands975e
the XP Snapshot S-VOL, the
command ends abnormally.
For information about using
XP Auto LUN, contact HP
technical support (see
(page 110)).
Since you specified the XP
Auto LUN reserved volume
All commands975f
as the XP Snapshot S-VOL,
the command ends
abnormally.
For information about using
XP Auto LUN, contact HP
technical support (see
(page 110)).
The XP Snapshot pair cannot
be created for any of the
following reasons:
paircreate9763
• The shared memory is not
increased.
• Initialization is in
process.
Unavailable parameter
(unsupported parameter) is
specified in the command.
paircreate976a
Since the command was
executed with the PSUE
pairsplit976c
option, the snapshot data
cannot be stored.
When an XP Snapshot P-VOL
and XP Continuous Access
pairsplit976e
S-VOL share the volume, the
status of the XP Continuous
Access pair is COPY.
Therefore, the snapshot data
cannot be stored.
When XP Snapshot P-VOL
and XP Continuous Access
pairsplit976f
Troubleshooting When Using XP RAID Manager 105