HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 26 Error Codes — Part Code 1005
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
6ESelect another volume.The specified volume cannot
be set as a command device
10021005
or a component of a LUSE
volume, because it is being
used as the volume of XP
Continuous Access, Business
Copy, Auto LUN, or XP
Snapshot.
Please select another volume.
6EThe configuration information
has been already changed.
You are trying to set multiple
paths to the same volume
from one group.
10031005
Check the settings, and
request the setting of the
configuration information
again.
6EThe configuration information
has been already changed.
Multiple volumes are
specified to a single port,
group or LUN combination.
10041005
Check the settings, and
request the setting of the
configuration information
again.
6EThe configuration information
has been already changed.
The following volumes cannot
be specified when you
10051005
Check the settings, and
request the setting of the
change the path
configurations:
• Volumes that do not exist
configuration information
again.
• Volumes other than the top
LUs in expanded LUs
• Volumes reserved by Auto
LUN
• System Disk volume
6ECheck the setting.Failed to remove the path.
The specified path is the last
10071005
path of the volumes used for
XP Continuous Access,
Business Copy, Auto LUN, or
XP Snapshot.
6EThe configuration information
has been already changed.
The emulation type of the
volumes is not for open
10091005
Check the settings, and
request the setting of the
systems, or the volumes are
not mounted. Check the
setting.
configuration information
again.
2EIf this problem persists, call
HP technical support.
An error occurred during SVP
processing. If this problem
10101005
persists, call HP technical
support.
2EThe volume that links as an
expanded LU extend over
An error occurred. If this
problem persists, call HP
technical support.
10111005
CU#. The error does not
occur normally because it is
guarded in the screen. In the
98 Remote Web Console for Storage System Messages and Error Codes